DFW series indicators DFW_03_12.07_EN_U
48
Example:
If the stored weigh is the following:
“PIDST,1, 1.000kg, 1.000kg,00126-131072”
and the following will be:
“PIDST,1, 1.000kg, 1.000kg,00127-000000”
The storage of a weigh is possible only if the weight is stable and valid (in other words not in underload nor in overload), if
the gross weight is equal or greater than zero and without the TILT alarm (see the paragraph “”TILT” DEVICE”).
The storage of the weigh by pressing a key is possible only if:
- the function is active (net weight passed from 0 or weight instability, or always depending on how the F.ModE >>
rEACt step has been configured in the technical set-up, TECH.MAN.REF.).
- the net weight is at least of 20 divisions with approved instrument.
If these conditions are not respected:
- in the response to the PID serial command one has "NO" in the place of the ID.
- there is no transmission if ENTER/PRINT has been pressed.
When the weight is transmitted with the ID following the pressing of the ENTER/PRINT key, the display shows for about 2
seconds the message " tr.id ", and the transmitted string is the following:
<ESC>[II]PIDSS,B,LLLLLLLLLLUU,YYTTTTTTTTTTUU,(ID | NO)<STX>.
See the following section “Serial commands” for the string description.
NOTES:
- With approved or not approved instrument, the storage of the weigh through the PID serial command is always possible
for all the weighs from 0 to full range value.
READING OF THE WEIGHS CARRIED OUT
In order to read the information relative to the weighs carried out:
- Press the MODE key.
- The message "rew.id" appears; now one should enter the rewriting number (from 00000 to 00255) and press
ENTER/PRINT.
- The message “ id “ appears; now one should enter the weigh number (from 000000 to 131072) and press
ENTER/PRINT.
- Now it is possible to view on the display the weigh information in sequence, and scroll through it with the ZERO key
(ahead) or the TARE key (backwards):
• "ch. x", in which x is the scale number (always 1).
• " um yy" in which yy is the unit of measure (kg, g, t o lb).
• gross weight (for about a second the message "GroSS" appears and then the gross weight value).
• Tare weight (for about a second the message "tArE" appears or "tArEpt" if it is a manual tare; then the tare value
appears).
- Press C to return to weighing.
NOTES:
- The alibi memory can store up to 131072 weighs; then the rewriting takes place from the beginning.
- If the alibi memory is empty, when the MODE key is pressed the message “EMPTY” appears for about a second, an
error acoustic signal is enabled and one returns to weighing.
- If the entered ID is not valid, in other words, if there is no stored weigh relative to the entered ID, the message " no id"
appears and an error acoustic signal is enabled and one returns to weighing.
INITIALISATION OF THE ALIBI MEMORY
It is possible to cancel all the weighs made, initialising the alibi memory; this operation can be made directly on the indicator
(see the parameter “SETUP” >> “ini.AL” of the set-up environment, TECH.MAN.REF.) or through the serial command (see
“SERIAL COMMANDS” below).
NOTES:
To Next Page
Loading...
