DAG Series User Manual
8
Dinstar Technologies Co., Ltd.
2. Basic Operations
2.1 Phone Call
2.1.1 Phone or Extension Numbers
1. Dial the number directly and wait for 3 seconds (Default “No dial timeout”);
2. Dial the number directly and press #.
Examples:
1. Dial an extension directly on the same proxy, (e.g. 8080), and then press the # or wait for 3
seconds.
2. Dial an outside number (e.g. (626) 666-8080), first enter the prefix number (usually 1+ or
international code) followed by the phone number. Press # or wait for 3 seconds. Check with your
VoIP service provider for further details on prefix numbers.
2.1.2 Direct IP Calls
Direct IP calling allows two parties, that is, a FXS Port with an analog phone and another VoIP
Device, to talk to each other in an ad hoc fashion without a SIP proxy.
Elements necessary to completing a Direct IP Call:
1. Both DAG serial and other VoIP Device, have public IP addresses;
2. Both DAG serial and other VoIP Device are on the same LAN using private IP addresses;
3. Both DAG serial and other VoIP Device can be connected through a router using public or
private IP addresses (with necessary port forwarding or DMZ).
1. Pick up the analog phone then dial “*47”
2. Enter the target IP address.
Note: No dial tone will be played between step 1 and 2.
Examples:
If the target IP address is 192.168.0.160, the dialing convention is *47, then 192*168*0*160.
Followed by pressing the “#” key or wait 3 seconds. Destination port is 5060.
NOTE:
You cannot make direct IP calls between FXS0 to FXS1 since they are using same IP. It only
supports the default destination port 5060. “Disable direct IP-IP calling” must be set to “No” in
web configuration page. “Call features enable” must be set to “Yes” in web configuration page.
To Next Page
Loading...
