DAG Series User Manual
11
Dinstar Technologies Co., Ltd.
3. Configuration Guide
3.1 Configure LAN Port’s IP Address
Connect to the FXS port and then telephone set:
1. Dynamic IP address by DHCP：
Offhook;
Input “*150*2#”;
Onhook;
If the equipment hint success, after 10 seconds, and restart the equipment. (Power-off then
power-on)
2. Static IP address：
Offhook;
Input “*150*1#”;
Onhook;
Then
（1） Configure IP address：
Offhook; input “*152*172*16*0*100# ”; onhook.
（2） Configure netmask：
Offhook; input “*153*255*255*0*0# ”; onhook.
（3） Configure gateway IP address (next hop)：
Offhook; input “*156*172*16*0*1# ”; onhook.
（4） if success, after 10 seconds, restart the equipment ;
3. Query the IP address of DAG1000 : Offhook, input “*158#”
4. If the DAG serial uses PPPoE method to get IP address，it need to configure by web browser.
NOTE: the telephone will play voice hint “Setting successfully” if the setting step is correct.
3.2 Access DAG Serial By Web Browser
DAG serial has an embedded Web server that will respond to HTTP GET/POST requests. It also
has embedded HTML pages that allow users to configure the DAG serial through a web browser
such as Microsoft’s IE .
3.2.1 Login
The DAG serial GUI configuration can be accessed via LAN or WAN port:
From the LAN port
1. Offhook, input *158# and get an IP address. The default gateway IP address: 192.168.11.1.
2. Directly connect a computer to the LAN port.
3. Open a command window on the computer.
4. Type in “ipconfig /release”, the IP address etc. becomes 0.
5. Type in “ipconfig /renew”, the computer gets an IP address in 192.168.11.x segment by default
To Next Page
Loading...
