Dinstar DAG2000 - System Configuration

DAG Series User Manual
20
Dinstar Technologies Co., Ltd.
3.3.4 System Configuration
System parameter includes 1) System Config 2) Service Config 3) SIP Config 4) Port Config 5)
Fax Config.
Figure 3-3-9 System Configuration
1. System Config
The page of system setting is mainly used to set some system parameters, including:
1)Provision Parameter; 2)NTP Parameter; 3)Time Zone
Figure 3-3-10 System Config
Table 3-3-3 System Config
Provision Parameter
Periodically, the server will automatically load the latest configuration
and version
NTP Parameter
NTP server management system time. Select "NTP Enable" to "YES",
you can configure the NTP server's IP and system time.