DWG2000C-4/8G User Manual
10 / 51
extension number ". Hang up after heard “setting successful".
4) Dial the phone number of the SIM card. Dial "*153*255*255*0*0#" after heard "dial the extension
number ". Hang up after heard "setting successful"
5) Dial the phone number of the SIM card. Dial "*156*172*16*1*1#" after heard "dial extension number
". Hang up after heard "setting successful"
6) Dial the phone number of the SIM card. Dial "*111#" after heard "dial extension number ", that will
restart the device
7) Dial the phone number of the SIM card. Dial "*158#" after heard “dial extension number ". It will play
report the IP address of LAN port.
3.4 DHCP Configuration
DHCP mode configure as follows:
1) Please make sure hardware installation have finished
2) Dial the phone number of the SIM card. Dial "*150*2#" after heard "dial extension number ". That
means the DHCP is configured successfully
3) Restart the device, wait for 30 seconds, and then dial the SIM card telephone number, enter "*158
#" to query the IP address
Note: If reporting the IP address is 0.0.0.0, which means that the gateway could not obtain a IP address
successfully. Please check:
1) Make sure the device have been connected to the network
2) Make sure the DHCP Server is working. If there is no DHCP Server, please set the IP of device to
static IP
3) Restart the gateway and try again
4. WEB Configuration
This charpter describes web configuration of DWG2000C-4/8G.
4.1 Access the System through HTTP
The default IP of LAN port is 192.168.11.1,before web access, make sure the PC is able to ping
continuously.
Here the device’s IP address is 172.16.80.89, after input this IP, the GUI shows as below:
Figure 4-1-1 WEB log interface
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
To Next Page
Loading...
