Dinstar DWG2000C - 2 Mobile Configuration

DWG2000C-4/8G User Manual
20 / 51
Remote API Enable
API is mainly for third party software which developed based-on Dinstar API
protocol. Its help to provide bulk SMS/ SMS/USSD over IP service.
API Server Address
It is the remote IP address who uses API. This is an option when selecting "Yes"
under 'remote API enable"
API Server Port
It is the port number of IP transmission. This is an option when selecting "Yes"
under "remote API enable". The port cannot conflict with the other application
software. The default value is 12000
Auto Reset Module
Reset modular by automatically while some special errors happened, such as
No Carrier, No Dial tone
Counts of No
CARRIER to reset
A kind of the error, continuously N times will reboot the modular.
N is range from 3 to 255.
Counts of No DIAL
TONE to reset
A kind of the error, continuously N times will reboot the modular.
N is range from 3 to 255.
4.6.2Mobile Configuration
Figure 4-6-2 Mobile State
Figure 4-6-3 Mobile Configuration
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846