DWG2000C-4/8G User Manual
38 / 51
4.12 System Configuration
4.12.1 Service Configuration
Service Configuration is used for configuring voice calls and some small businesses, such as Call
Progress Tone, codec, silence suppression, * service, the second dial and so on
Figure 4-12-1 Service Configuration
Table 4-12-1 Description of Service Configuration
Means the initial port when RTP voice stream transmit in the IP network , in
general, using the factory default values. When there are multiple DINSTAR
series voice products, and the network gateway or router’s NAT with
loopholes, user can try changing this item
To Next Page
Loading...
