Dinstar DWG2000C - 4.12.2 SIP Configuration

DWG2000C-4/8G User Manual
40 / 51
from IP to PSTN
Use # as End Key
In General, SIP phones are based on # as the end, if this option is set to No, the
dial-up will end expires dial-up time
Interdigit Timeout
Bit of between the dialing time ,over the time will be seem as end of dial
4.12.2 SIP Configuration
Figure 4-12-2 SIP Configuration
Table 4-12-2 SIP Configuration
SIP Server
Address
Used for configure SIP server address and port, the address can be IP Address,
also can be a domain nameWhich can be resolved by DNS server
SIP Proxy Port
Port default setting is 5060. For details, please consult the service provider
Outbound Proxy
Outbound proxy, it mainly used in firewall / NAT environment. That make the
signaling and media streams are able to penetrate the firewall
Use Random Port
Set the local monitor SIP port ( fixed or random ) , random is every time you start
the device will random Select a free SIP port For listening
Is Register
Default set yes, if you want the device can make a call without register, set No, Also
enable the "Allow Call from IP to PSTN without Registration" and "Allow Call from
PSTN to IP without Registration" function
Register Interval
Means how often the equipment will register to the SIP server/proxy
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846