29
© 2009 Directed Electronics. All rights reserved.
Channel Function
3
Reset Features: This resets all of the system features to the factory default
settings.
Note: This feature does not delete the remotes from the system or reset the
Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual Tach,
and on the next remote start sequence the unit begins virtual tach initial-
ization.
Note: The “Zap” feature on the Bitwriter does not reset the Virtual tach
setting.
3.
Transmit.
While
HOLDING
the Program
switch, press the
button to program the remote
or to reset one of the features in the remote pro-
gramming grid. The horn honks to confirm that the
code has been successfully programmed. It is not
possible to teach a remote control to the system
more than once.
4.
Release.
Once the code is learned, the Program
switch can be released.
You can advance from programming one channel to another by releas-
ing the Program switch and tapping it to advance steps and then hold-
ing it. For instance: You have programmed Channel One and you want
to program Channel Two. Release the Program switch. Press it one time
and release it to advance from Channel One to Channel Two. Now,
press and
HOLD
the Program switch. The LED will flash two times, do
not release it.
To Next Page
Loading...
