Directed Electronics Avital - Page 33

33
© 2009 Directed Electronics. All rights reserved.
ON. Pressing

on the remote will cycle through the available op-
tions in each feature.
5. Release. The Program switch can now be re-
leased.
You can advance from feature to feature by pressing and releasing the
Program switch the number of times necessary to get from the feature
you just programmed to the feature you wish to access. For example,
in Menu One, if you just programmed feature 1-3 to off, and you want
to program the next feature 1- 4, release the Program switch. Press and
release it once to advance from Feature 1-3 to Feature 1- 4. Then press
it once more and
HOLD it. The LED will flash in groups of 4 to confirm
that you have accessed Feature 1- 4.
The learn routine will be exited if any of the following occurs:
• The ignition is turned on.
• The Program switch is pressed too many times.
• More than 25 seconds elapses between programming steps.