To Next Page
E
Eric HoffmanSep 23, 2025
What to do if Directed Door locks ISO 2 not detected?
- Aanna35Sep 23, 2025
The Orange/Black wire did not detect the expected signal.
What to do if Directed Door locks ISO 2 not detected?
The Orange/Black wire did not detect the expected signal.
What to do if Directed Door locks MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value.
What to do if Directed Automobile Accessories bypass processing error occurs?
The bypass calculation failed. Reset the Directed module and try again.
Why is Directed Automobile Accessories 'waiting to begin the programming sequence'?
Ensure the correct programming procedure is being followed.
What does it mean if Directed Automobile Accessories PTS shutdown error occurred?
The PTS output from the Directed module was not activated due to safety protection.
What to do if Directed DB3 Automobile Accessories shows 'Bypass data not detected'?
If the Directed Automobile Accessories module shows 'Bypass data not detected', verify the bypass line connection. If multiple wires are involved, ensure they are correctly oriented. Also, make sure the vehicle functions properly with the factory key.
What to do if Directed DB3 Automobile Accessories shows 'CAN1 not detected'?
If your Directed Automobile Accessories module displays 'CAN1 not detected', check the connections of the CAN1 Tan and Tan/Black wires. Try waking up the data bus by turning the ignition on and attempting the process again. If the installation doesn't need this connection, you can skip it by pressing the programming button five times.
What to do if Directed DB3 shows 'CAN2 not detected'?
If the Directed Automobile Accessories module displays 'CAN2 not detected', check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, you can skip this step by pressing the programming button 5 times.
What to do if Directed DB3 shows 'J1850 not detected'?
If your Directed Automobile Accessories module displays 'J1850 not detected', check the J1850 wire connection. Try waking up the data bus by turning the ignition on and try again.
What to do if Directed Automobile Accessories shows 'Bypass processing error'?
If the Directed Automobile Accessories module shows 'Bypass processing error', reset the module and try again.
Describes the DB3 as a universal, flashable data-bus interface module.
Highlights the DB3's capability to cover over 90% of vehicles on the road today.
Lists features like RSR/RXT compatibility, programmable functions via Directechs, and RF loop support.
Details compatibility with RSR, RXT, SmartStart, and 3X Lock Start systems.
Mentions the ability to configure the module using a flash module.
Explains the warranty for Directed interfaces ensuring high-speed digital connectivity and error-free data exchange.
Warns users to check for hood detection switches before servicing to prevent unexpected restarts.
General| Brand | Directed |
|---|---|
| Model | DB3 |
| Category | Automobile Accessories |
| Language | English |
