What to do if Directed Remote Starter CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed Remote Starter J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What to do if Directed Remote Starter initialization failed?
Reset the module and complete the programming again. If the issue persists, please contact Technical Support.
What to do if Directed Remote Starter bypass processing error?
The bypass calculation failed. Reset the module and try again. If the condition persists, please contact Technical Support.
What to do if Directed Remote Starter MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Remote Starter waiting to begin the programming sequence?
Make sure you are following the correct programming procedure.
What to do if Directed Remote Starter transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if Directed Remote Starter ISO 1 not detected?
The Yellow/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Remote Starter OBDII feature not supported?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Why Directed Remote Starter PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
Describes the DB3 as a universal, flashable data-bus interface module.
Highlights the DB3's capability to cover over 90% of vehicles on the road today.
Lists features like RSR/RXT compatibility, programmable functions via Directechs, and RF loop support.
Details compatibility with RSR, RXT, SmartStart, and 3X Lock Start systems.
Mentions the ability to configure the module using a flash module.
Explains the warranty for Directed interfaces ensuring high-speed digital connectivity and error-free data exchange.
Warns users to check for hood detection switches before servicing to prevent unexpected restarts.
General| Brand | Directed |
|---|---|
| Model | DB3 |
| Category | Automobile Accessories |
| Language | English |
To Next Page
