Directed DB3 - User Manual

6 pages

Save Page as PDF

To Next Page

DIRECTED

Other manuals for Directed DB3

Installation Guide25 pages

Questions and Answers

R
Ryan StantonSep 12, 2025
What to do if Directed Automobile Electronics CAN bus incorrectly detected?
- C
  Clarence RichardSep 12, 2025
  Verify the CAN1 and CAN2 connections.
C
Cody MartinezAug 29, 2025
What does MUX not detected mean for Directed Automobile Accessories?
- J
  jacquelinehessAug 29, 2025
  If MUX is not being detected by your Directed Automobile Accessories, the Violet/Green or Violet/Brown wire didn't detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
C
Carrie CamachoSep 9, 2025
What does a feature error mean in Directed Automobile Accessories?
- J
  Jose BrownSep 10, 2025
  If the Directed Automobile Accessories system indicates a feature error, an RSR feature file mismatch was detected. Please contact Technical Support.
S
Steven RochaSep 12, 2025
What to do if Directed Remote Starter transponder functions were skipped?
- B
  Bradley BrockSep 12, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
M
Matthew BernardSep 16, 2025
Why Directed Door locks waiting to begin the programming sequence?
- D
  Douglas HayesSep 16, 2025
  Ensure the correct programming procedure is being followed for the Directed Door locks.
L
Lori KiddSep 23, 2025
What to do if Directed Automobile Accessories shows 'MUX not detected'?
- D
  Douglas MoodySep 23, 2025
  If the Directed Automobile Accessories module displays 'MUX not detected', the Violet/Green or Violet/Brown wire didn't detect the expected voltage value. Check the connections, referring to “Installation (wiring diagrams & vehicle wiring reference charts)”.
W
weaveremmaAug 29, 2025
What to do if J1850 not detected on Directed DB3 Automobile Accessories?
- N
  nreeseAug 29, 2025
  If J1850 is not being detected by your Directed Automobile Accessories, check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
C
Christopher PowersAug 28, 2025
What does bypass processing error mean for Directed DB3?
- P
  Patricia CampbellAug 28, 2025
  If you encounter a bypass processing error with your Directed Automobile Accessories, reset the module and try again. If the problem continues, please contact Technical Support.
M
megangalvanAug 28, 2025
Why is my Directed Automobile Accessories waiting to begin programming?
- L
  Laurie WilsonAug 28, 2025
  If your Directed Automobile Accessories module is stuck waiting to begin the programming sequence, double-check that you're following the correct programming procedure.
V
Victoria BuckleyAug 28, 2025
What to do if CAN2 is not detected on Directed DB3 Automobile Accessories?
- R
  Richard WatsonAug 28, 2025
  If CAN2 isn't being detected by your Directed Automobile Accessories, check the connections of the Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.