Why Directed DB3 Automobile Accessories transponder functions were skipped?
If the Directed Automobile Accessories system indicates 'Transponder functions were skipped' when RXT mode is not desired or convenience features are needed, please reset and reprogram the module.
Why is RFTD disabled in Directed DB3 Automobile Accessories?
RFTD is disabled in your Directed Automobile Accessories because 3x OEM Lock Remote Start Activation was attempted when the RFTD feature is disabled. Make sure 3x Lock Start is selected from the web in the flashing process.
What to do if Directed Automobile Electronics CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections.
What does 'Runsafe was not disabled' mean for Directed DB3 Automobile Accessories?
If the Directed Automobile Accessories system indicates that Runsafe was not disabled, it means that no UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if CAN2 is not detected in Directed Automobile Electronics?
If CAN2 isn't being detected by your Directed Automobile Electronics, check the CAN2 Orange/Green and Orange/Brown wire connections. You might need to wake up the data bus by turning the ignition on and then try again. If your installation doesn't need this connection, you can skip this step by pressing the programming button 5 times.
What to do if I get a bypass processing error on my Directed Car Alarm?
If you encounter a bypass processing error with your Directed Car Alarm, reset the module and try again. If the condition persists, further assistance may be needed.
What to do if CAN2 is not detected on Directed DB3 Automobile Accessories?
If CAN2 isn't being detected by your Directed Automobile Accessories, check the connections of the Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
Why is my Directed Automobile Accessories waiting to begin programming?
If your Directed Automobile Accessories module is stuck waiting to begin the programming sequence, double-check that you're following the correct programming procedure.
What to do if Directed Automobile Accessories shows 'ISO 1 not detected'?
If the Directed Automobile Accessories module shows 'ISO 1 not detected', the Yellow/Black wire did not detect the expected signal. Check the connections, referring to “Installation (wiring diagrams & vehicle wiring reference charts)”.
What does it mean if OBDII feature is not supported in Directed Automobile Accessories?
If the OBDII feature isn't supported in your Directed Automobile Accessories, it means the diagnostic data bus wasn't detected, which will limit the SmartStart features.
Describes the DB3 as a universal, flashable data-bus interface module.
Highlights the DB3's capability to cover over 90% of vehicles on the road today.
Lists features like RSR/RXT compatibility, programmable functions via Directechs, and RF loop support.
Details compatibility with RSR, RXT, SmartStart, and 3X Lock Start systems.
Mentions the ability to configure the module using a flash module.
Explains the warranty for Directed interfaces ensuring high-speed digital connectivity and error-free data exchange.
Warns users to check for hood detection switches before servicing to prevent unexpected restarts.
General| Brand | Directed |
|---|---|
| Model | DB3 |
| Category | Automobile Accessories |
| Language | English |
To Next Page
