What to do if Directed DS3+ Automobile Accessories bypass data not detected?
Check the bypass line connection. If there's more than one wire, ensure they aren't inverted. Also, make sure the vehicle still operates correctly using the factory key.
Why is the CAN bus incorrectly detected in my Directed Remote Starter?
Verify the CAN1 and CAN2 connections.
What to do if my Directed Remote Starter shows that ISO 2 is not detected?
The Orange/Black wire didn't detect the expected signal. Check the connections.
Why Directed Automobile Accessories OBDII feature is not supported?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited in your Directed Automobile Accessories.
What to do if Directed DS3+ has DEI feature error?
Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
What causes a bypass processing error in Directed Automobile Accessories?
Reset the module and try again. If the condition persists, please contact Technical Support.
What to do if Directed Automobile Accessories transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
Why is Directed Automobile Accessories showing 'Speed was detected'?
The vehicle was detected as moving, which prevents the system from shutting it down.
What does it mean if Directed Automobile Accessories PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if Directed Remote Starter is waiting to begin the programming sequence?
Make sure that you are following the correct programming procedure.
General| Type | Remote Start System |
|---|---|
| Smartphone Control | No |
| Range | Up to 3000 feet |
| Connectivity | RF (Radio Frequency) |
| Operating Frequency | 433 MHz |
| Battery Type | CR2032 |
| Button Configuration | 4-button |
| LED Indicator | Yes |
To Next Page