To Next Page
C
Connor DunnSep 23, 2025
What to do if Directed DS3+ has a DEI feature error?
- MMatthew WilsonSep 23, 2025
A feature config file mismatch was detected. No other solution is available.
What to do if Directed DS3+ has a DEI feature error?
A feature config file mismatch was detected. No other solution is available.
What does it mean if Directed DS3+ runsafe was not disabled?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if my Directed DS3+ module has no power?
First, check that the D2D harness is connected and that there is 12 Volts between the red and black wires. If 12 Volts is present, it is possible that the module is defective.
What to do if Directed Automobile Accessories shows 'Bypass data not detected'?
Check the connection of the bypass line. If you're using more than one wire, ensure they are not inverted. Also, make sure the vehicle still works correctly with the factory key.
What to do if Directed DS3+ Automobile Accessories shows 'Bypass processing error'?
The bypass calculation has failed. Reset the module and try again.
Why is my Directed DS3+ showing 'ISO 1 not detected'?
The Yellow/Black wire did not detect the expected signal. Check the connections.
Why is my Directed Automobile Accessories showing 'ISO 2 not detected'?
The Orange/Black wire did not detect the expected signal. Check the connections.
What does it mean when my Directed Automobile Accessories says 'MUX not detected'?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
General| Type | Remote Start System |
|---|---|
| Smartphone Control | No |
| Range | Up to 3000 feet |
| Connectivity | RF (Radio Frequency) |
| Operating Frequency | 433 MHz |
| Battery Type | CR2032 |
| Button Configuration | 4-button |
| LED Indicator | Yes |
