Why Directed Automobile Accessories OBDII feature is not supported?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited in your Directed Automobile Accessories.
Why Directed DS3+ PTS shutdown error?
The PTS output from the Directed Automobile Accessories module was not activated due to safety protection.
What to do if Directed DS3+ Automobile Accessories CAN1 not detected?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed DS3+ CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed DS3+ Automobile Accessories J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What does 'Waiting to begin the programming sequence' mean for Directed DS3+ Automobile Accessories, and how to solve it?
This indicates that the programming sequence is not starting. To resolve this, ensure you are following the correct programming procedure.
What does it mean 'Initialization failed' for Directed Automobile Accessories?
Reset the module and complete the programming again. If the issue persists, please contact Technical Support.
What does 'Bypass processing error' mean for Directed DS3+?
The bypass calculation failed. Reset the module and try again. If the condition persists, please contact Technical Support.
Why Directed DS3+ Automobile Accessories transponder functions were skipped?
If compatible, when the RXT mode is not desired or convenience features are needed, please reset and reprogram the module.
What does it mean 'Bypass and CAN were skipped' in Directed DS3+?
This means that the programming button was pressed 5 times to skip bypass and 5 times to skip the CAN.
General| Type | Remote Start System |
|---|---|
| Smartphone Control | No |
| Range | Up to 3000 feet |
| Connectivity | RF (Radio Frequency) |
| Operating Frequency | 433 MHz |
| Battery Type | CR2032 |
| Button Configuration | 4-button |
| LED Indicator | Yes |
To Next Page