What to do if ISO 2 is not detected in Directed DS3+ Automobile Accessories?
If the ISO 2 is not detected in your Directed Automobile Accessories because the Orange/Black wire did not detect the expected signal, check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.
What to do if MUX is not detected in Directed DS3+?
If the MUX is not detected in your Directed Automobile Accessories because the Violet/Green or Violet/Brown wire did not detect the expected voltage value, check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.
How to fix CAN bus if it's incorrectly detected in Directed DS3+ Automobile Accessories?
If the CAN bus is incorrectly detected in your Directed Automobile Accessories, verify the CAN1 and CAN2 connections. Check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.
What does PTS shutdown error mean on my Directed Remote Starter?
A PTS shutdown error on your Directed Remote Starter means the PTS output from the module was not activated due to safety protection.
How to troubleshoot a Directed Remote Starter module with no power?
If your Directed Remote Starter module isn't getting power, first ensure the D2D harness is properly connected. Then, check if there's 12 Volts present between the red and black wires. If the voltage is correct, the module itself might be defective.
What to do if my Directed Remote Starter shows CAN1 not detected?
If your Directed Remote Starter shows a 'CAN1 not detected' error, check the connections of the CAN1 Tan and Tan/Black wires. Try waking up the data bus by turning the ignition on and attempting the process again. If the installation doesn't need this connection, you can skip the step by pressing the programming button 5 times.
What to do if my Directed Remote Starter shows CAN2 not detected?
If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
What to do if my Directed Remote Starter says bypass data not detected?
If your Directed Remote Starter indicates that bypass data is not detected, check the bypass line connection. If you're using multiple wires, make sure they aren't inverted. Also, ensure that the vehicle still operates correctly using the factory key.
What to do if my Directed Remote Starter is not detecting J1850?
If your Directed Remote Starter isn't detecting J1850, check the J1850 wire connection. Then, wake up the data bus by turning the ignition on and trying again.
What to do if my Directed Remote Starter initialization failed?
If the initialization process fails on your Directed Remote Starter, reset the module and try the programming sequence again. If the issue continues, further assistance may be needed.
General| Type | Remote Start System |
|---|---|
| Smartphone Control | No |
| Range | Up to 3000 feet |
| Connectivity | RF (Radio Frequency) |
| Operating Frequency | 433 MHz |
| Battery Type | CR2032 |
| Button Configuration | 4-button |
| LED Indicator | Yes |
To Next Page