To Next Page
W
Wesley PageSep 12, 2025
What to do if my Directed Remote Starter shows that ISO 1 is not detected?
- SSamantha AliSep 12, 2025
The Yellow/Black wire didn't detect the expected signal. Check the connections.
What to do if my Directed Remote Starter shows that ISO 1 is not detected?
The Yellow/Black wire didn't detect the expected signal. Check the connections.
What to do if my Directed Remote Starter shows a bypass processing error?
If your Directed Remote Starter encounters a bypass processing error, reset the module and try again. If the problem persists, further assistance may be needed.
What to do if my Directed Remote Starter is waiting to begin the programming sequence?
If your Directed Remote Starter is stuck waiting to begin the programming sequence, ensure that you are following the correct programming procedure.
Why was Runsafe not disabled on my Directed Remote Starter?
If the Runsafe feature wasn't disabled on your Directed Remote Starter, it's likely because no UNLOCK command was received before opening the door, or the 45-second timer expired in takeover mode.
What to do if transponder functions were skipped on my Directed Remote Starter?
If transponder functions were skipped on your Directed Remote Starter, and if compatible, when the RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if my Directed Remote Starter shows that ISO 2 is not detected?
The Orange/Black wire didn't detect the expected signal. Check the connections.
What to do if my Directed Remote Starter says CAN bus incorrectly detected?
If the CAN bus is incorrectly detected by your Directed Remote Starter, verify the CAN1 and CAN2 connections.
What to do if my Directed Remote Starter shows that MUX is not detected?
The Violet/Green or Violet/Brown wire didn't detect the expected voltage value. Check the connections.
Why does my Directed Remote Starter say that the brake was not detected?
The brakes were not detected, which prevents the Directed Remote Starter system from shutting down the vehicle.
Why does my Directed Remote Starter say that the smart key was not detected?
The smart key was not detected, which prevents the Directed Remote Starter system from shutting down the vehicle.
General| Type | Remote Start System |
|---|---|
| Smartphone Control | No |
| Range | Up to 3000 feet |
| Connectivity | RF (Radio Frequency) |
| Operating Frequency | 433 MHz |
| Battery Type | CR2032 |
| Button Configuration | 4-button |
| LED Indicator | Yes |
