B-3
Operation flow (Continued)
1-13 Application of Power to Machine
1-14 Supply Air Pressure Check
1-15 Wheel Coolant Flow Check
1-16 Spindle Coolant Flow Check
Safety precautions in installing the machine
WARNING
Air exhaust, water drainage, and grinding dust must be properly managed/
disposed in compliance with applicable environmental regulations
Due to the nature of its processing characteristics, the machine may produce harmful
substances depending on the types of workpieces it grinds.
It is recommended that the installed machine be secured with anchors of the
machine
DISCO provides the optional machine anchors for human/equipment protection in case
of an earthquake or other disaster.
The floor on which the machine is installed should be provided with sufficient
waterproofing and drainage treatment
If water leakage should occur, the floor surface and downstairs might be damaged.
Periodically inspect the water pipe fittings to make sure that no water leaks from
them
If water leakage should occur, the floor surface and downstairs might be damaged.
NOTICE
Use the safety goggles, protective gloves, stepstools, flashlights and alcohol
which are available in your factory or comply with your factory's standards
Safety goggles, protective gloves, stepstools, flashlights and alcohol are not supplied
with the machine.
To Next Page
Loading...