B-23
1-6. Power Cable Connection
Summary of this section
This section describes the procedures to install the power cable to the machine main body as well as the
procedures to connect the power cables of the accessory units to the machine in the flow of the operation
steps indicated below.
1-6-1 Power Cable Installation to Machine Main Body
1-6-2 Connection of Power Cable of Vacuum Unit [Optional Accessory]
1-6-3 Connection of Power Cable of Booster Pump Unit [Optional Accessory]
1-6-4 Connection of Power Cable of Duct Unit [Optional Accessory]
1-6-5 Connection of Power Cable of Coolant Unit [Optional Accessory]
1-6-6 Connection of Signal Cables of Water Temperature Control Unit (DTU152)
[Optional Accessory]
To Next Page
Loading...