B-42
1-13. Application of Power to Machine
Procedures to apply power to the machine
WARNING
When the machine or floor is wet with water, do not touch the machine or wet
floor. Also, turn OFF the facility power source and lock it out with a padlock or the
like.
Also, never turn ON the facility power source until the machine and floor completely
dry. There is an electric hazard which could result in death or serious injury. Even
when the machine power is turned off, it will remain energized until the facility power
source is turned OFF.
Step No.
Procedure
(Continued from the previous section)
1
Turn the main power circuit breaker lever on the rear of the machine clockwise to "ON"
position.
・If the breaker lever is locked out, release the lockout.
Breaker lever
2
Insert the machine switch key to its key slot on the front of the machine and turn it
clockwise until it stops and leave the key there.
・The machine power turns ON.
Turn the key
clockwise
To Next Page
Loading...