B-33
1-6-6. Connection of Signal Cables of Water Temperature Control
Unit (DTU152)
Equipment you must have ready
Phillips screwdriver
Slotted screwdriver
Procedures to connect the signal cables of the water temperature control unit to the machine
Step No.
Procedure
(Continued from the previous section)
1
Connect the signal lines of the water temperature control unit (DTU152) to their
connectors (J106, J107) on the panel located at the bottom part of the control box.
Connector panel
[Bottom part as viewed from below]
Continued in the next section.
To Next Page
Loading...