DITEC EL20 - Application Examples; Application Example Without Selector; Application Example with COMH-COMK Selector

GB
15
EL20 - IP1951
5. APPLICATION EXAMPLE WITHOUT SELECTOR
The automation opens with commands 1-3A, 1-3B of the RADAR, and automatically closes with jumper 1-2.
Make the safety on the passage opening with CELPR photocells.
The switch between 1-9 stops the automation at that point and no other normal or emergency operation is permitted.
Contact 1-29 can be used for the POWER RESET of the control panel.
6. APPLICATION EXAMPLE WITH COMH-COMK SELECTOR
The automation opens with the 1-3A, 1-3B RADAR commands and automatically closes based on the operation chosen on the
selector. Make the safety across the passage opening with the CELPR photocells.
With the selector in the STOP position all normal and emergency operations are excluded.
Contacts 41-6 and 41-8 are independent from the selector, therefore they must have jumpers if not in use.
The POWER RESET of the control panel is available on the operations selector switch.
POWER
RESET
STOP
RADAR B RADAR A
24 V
+
-
24 V
+
-
COM
VA
DIP
OPEN
J1 J2 J3
VC TC RP R1
on
off
POWER
ALARM
SA
IN
1 2 3 4 5 6
0 1 1 2 3A 3B 9 27 28 29
0 1 6 8 41
0 1 21 22
EL20
P1 R1
P1 SP P2
R1 SR R2
CELPR
RADAR B RADAR A
24 V
+
-
24 V
+
-
COM
VA
DIP
VC TC RP R1
on
off
POWER
ALARM
SA
IN
1 2 3 4 5 6
0 1 1 2 3A 3B 9 27 28 29
0 1 6 8 41
0 1 21 22
EL20
27 28 29 1 2 A B 9
COMH
COMK
OPEN
J1 J2 J3
P1 R1
P1 SP P2
R1 SR R2
CELPR