33
IP2251EN
AP - Advanced Parameters
Display Description
Selections
available
TN - Setting of intervention temperature for NIO electronic anti-freeze
system and automatic HS ramps [°C]
This value does not refer to the ambient temperature, but to the internal
control panel temperature.
20
HS - Automatic ramp adjustment
ON - Enabled
OF - Disabled
When enabled (ON), at low ambient temperatures the start time
increases up
to the maximum value and the acceleration time
and diminishes to the
minimum value.
NOTE: for correct operation, the control panel must be exposed to the same am-
bient temperature as the motors. The intervention temperature can be set with
the selection
→ .
TB - Permanent display of the internal control panel temperature [°C]
WO - Setting of pre-flashing time on opening [s]
Adjustment of the lead time for the switch-on of the flashing light, in
relation to the start of the opening operation from a voluntary command.
00 - Minimum
05 - Maximum
00
WC - Setting of pre-flashing time on closing [s]
Adjustment of the lead time for the switch-on of the flashing light, in
relation to the start of the closing operation from a voluntary command.
00 - Minimum
05 - Maximum
00’’
TS - Setting of renewal of automatic closing time after safety device
release [%]
00 - Minimum
99 - Maximum
99
VR - Setting of learning speed [V]
See paragraph 11.2.1
12. Signals visualised on the display
NOTE: depending on the type of automation and control panel, certain visualisations may
not be available.
12.1 Display of automation status
NOTE: the automation status display mode is only visible with Display visualisation mode
set to 02.
Display Description Display Description
Automation closed Automation opening
Automation open Automation closing, from partial opening
To Next Page
Loading...
