13
IP2320
EN
General safety precautions
This installation manual is intended for qualified personnel only •Installation, electrical connections and
adjustments must be performed by qualified personnel, in accordance with Good Working Methods and in
compliance with the current regulations • Read the instructions carefully before installing the product. Wrong
installation could be dangerous • Before installing the product, make sure it is in perfect condition •
The packaging materials (plastic, polystyrene, etc.) should not be discarded in the environment
or left within reach of children, as they are a potential source of danger • Do not install the pro-
duct in explosive areas and atmospheres: the presence of inflammable gas or fumes represents a
serious safety hazard • Make sure that the temperature range indicated in the technical specifications
is compatible with the installation site • Before installing the motorization device, make sure that the
existing structure, as well as all the support and guide elements, are up to standards in terms of
strength and stability. Verify the stability and smooth mobility of the guided part, and make sure that
no risks of fall or derailment subsist. Make all the necessary structural modifications to create safe-
ty clearance and to guard or isolate all the crushing, shearing, trapping and general hazardous areas
• The motorization device manufacturer is not responsible for failure to observe Good Working Methods
when building the frames to be motorized, or for any deformation during use • The safety devices
(photocells, safety edges, emergency stops, etc.) must be installed taking into account the applicable
laws and directives, Good Working Methods, installation premises, system operating logic and the
forces developed by the motorized door or gate • The safety devices must protect against crushing,
cutting, trapping and general danger areas of the motorized door or gate. Display the signs required
by law to identify hazardous areas. Each installation must bear a visible indication of the data iden-
tifying the motorized door or gate • Before connecting the power supply, make sure the plate data
correspond to those of the mains power supply. An omnipolar disconnection switch with a contact
opening distance of at least 3mm must be fitted on the mains supply. Check that there is an adequa-
te residual current circuit breaker and a suitable overcurrent cutout upstream of the electrical instal-
lation in accordance with Good Working Methods and with the laws in force • When requested, connect
the motorized door or gate to an effective earthing system that complies with the current safety
standards • Before commissioning the installation to the end user, make sure that the automation is
adequately adjusted in order to satisfy all the functional and safety requirements, and that all the
command, safety, and manual release devices operate correctly •
During installation, maintenance and repair operations, cut off the power supply before opening
the cover to access the electrical parts • The protection cover of the operator must be removed
by qualified personnel only.
The electronic parts must be handled using earthed antistatic conductive arms. The manufac-
turer of the motorization declines all responsibility if component parts not compatible with safe
and correct operation are fitted • Only use original spare parts for repairing or replacing products
• The installer must supply all information concerning the automatic, manual and emergency ope-
ration of the motorized door or gate, and must provide the user with the operation and safety in-
structions.
ATTENTION! Important safety instructions.
Please follow these instructions carefully. Failure to observe the information given in this manual
may lead to severe personal injury or damage to the equipment.
Keep these instructions for future reference.
This manual and those for any accessories can be downloaded from www.ditecautomations.com.
To Next Page
Loading...
Need help?
General
