dji AGRAS T30

©
2022 DJI All Rights Reserved.
57
AGRAS T30
Unmanned Aircraft Flight Manual
1. DO NOT use swollen, leaking, or damaged batteries.
2. DO NOT use a battery that has been dropped.
3. If the battery falls into water while inserted in an aircraft during ight, take it out immediately, and put
it in a safe and open area. DO NOT use the battery again.
4. If the battery cannot be discharged completely, replace the battery and contact a professional
battery recycle company for assistance on disposal.
Maintenance Program
Operator Performing List
1. Clean all parts of the aircraft at the end of each day of spraying after the aircraft returns to a normal
temperature. DO NOT clean the aircraft immediately after operations are completed.
a. Fill the spray tank with clean water or soapy water and spray the water through the nozzles until
the tank is empty. Repeat the step two more times.
b. Remove the spray tank strainer, nozzle strainers, and nozzles to clean them and clear any
blockage. Afterwards, immerse them in clean water for 12 hours.
c. Make sure that the aircraft structure is completely connected so that it can be washed directly
with water. It is recommended to use a spray washer lled with water to clean the aircraft body
and wipe with a soft brush or wet cloth before removing water residue with a dry cloth.
d. If there is dust or pesticide liquid on the motors, propellers, or heat sinks, wipe them with a wet
cloth before cleaning the remaining water residue with a dry cloth.
e. Store the cleaned aircraft in a dry environment.
2. Wipe the surface and screen of the remote controller with a clean wet cloth that has been wrung out
with water daily after operations.
3. Inspect the aircraft every 100 ights or after ying for over 20 hours:
a. Check for and replace worn propellers.
b. Check for loose propellers. Replace propellers and propeller washers if needed.
c. Check for aging plastic or rubber parts.
d. Check for poor atomization of the nozzles. Clean nozzles thoroughly or replace them.
e. Replace nozzle strainers and the spray tank strainer.
4. Keep the protective cover of the radar module clean. Clean the surface with a soft damp cloth and
air dry before using again.
5. Keep the FPV camera clean. First remove any larger pieces of grit or sand then wipe the lens with a
clean, soft cloth to remove dust or other dirt.
Notice
1. In the event of a crash or collision, make sure to thoroughly inspect every part of the aircraft and
make any necessary repairs and replacements before your next ight. If you have any problems or
questions, contact DJI Support or a DJI authorized dealer.
2. DO NOT attempt to repair the aircraft if any parts are damaged. Contact DJI Support or a
DJI authorized dealer for professional maintenance services. The T30 Drone Recommended
Maintenance Cycle table in the Supplements section lists the recommended maintenance cycle and
item maintenance performed by DJI authorized dealers only.
3. When a replacement part is required, make sure to purchase the new part from a DJI authorized
dealer only.
Find the dealer information from https://www.dji.com/where-to-buy/agriculture-dealers