dji AGRAS T30

©
2022 DJI All Rights Reserved.
37
AGRAS T30
Unmanned Aircraft Flight Manual
Takeoff/Landing
The Combination Stick Command (CSC) listed below is used to start and stop the motors. Make sure
you perform the CSC in one continuous motion. The motors begin to accelerate at an idle speed.
Release both sticks simultaneously. Take off immediately once the motors are spinning, or else the
aircraft may lose balance, drift, or even takeoff by itself and risk causing damage or injury.
Takeo
Perform a Combination Stick Command (CSC) and push the throttle stick up to take off.
OR
Throttle Stick
(left stick in Mode 2)
Landing
To land, pull down on the throttle stick to descend until the aircraft touches the ground. There are two
methods to stop the motors.
Method 1: when the aircraft has landed, push and hold the throttle stick down. The motors will stop after
three seconds.
Method 2: when the aircraft has landed, push the throttle stick down, and perform the same CSC that
was used to start the motors. Release both sticks once the motors have stopped.
Method 1 Method 2
OR
Spinning propellers can be dangerous. Stay away from spinning propellers and motors. DO
NOT start the motors in conned spaces or where there are people nearby.
Maintain control of the remote controller as long as the motors are running.
DO NOT stop the motors mid-flight unless in an emergency situation where doing so will
reduce the risk of damage or injury.
It is recommended to use Method 1 to stop the motors. When using Method 2 to stop the
motors, the aircraft may roll over if it is not completely grounded. Use Method 2 with caution.
After landing, power off the aircraft before turning off the remote controller.