dji AGRAS T30

68
©
2022 DJI All Rights Reserved.
AGRAS T30
Unmanned Aircraft Flight Manual
3. Connect the device to the USB-A port on the remote controller to update the rmware of the battery
station. Tap the dropdown menu for each device and select the firmware. There will be a check
mark on the device displayed in the app when a rmware is selected for the corresponding device.
Uncheck the mark to cancel the update.
4. Tap Update All to redirect to the update screen. The app will download the rmware for all selected
devices and update automatically.
5. Make sure all the devices are connected to the remote controller and wait for the update to complete.
6. After successfully completing the update, restart the remote controller and the aircraft manually.
DJI Assistant 2 for MG
Configure settings of the basic parameters, copy flight records, and update aircraft and remote
controller rmware in DJI Assistant 2 for MG.
Installation and Launching
1. Download the DJI Assistant 2 for MG installation le from the T30 download page:
https://www.dji.com/t30/downloads
2. Install the software.
3. Launch DJI Assistant 2 for MG.
Using DJI Assistant 2 for MG
Connecting the Aircraft
Connect the USB-C port on the bottom of the aircraft to a computer with a USB-C cable, and then power
on the aircraft.
Make sure to remove the propellers before using DJI Assistant 2 for MG.
Remove the waterproof cover on the USB-C port before use. Attach the waterproof cover to the
port after use. Otherwise, water may enter the port, causing it to short circuit.
Firmware Update
A DJI account is required for rmware updates. Login or register an account.
Exporting Log
View all the logs of the aircraft and select logs to export.
Simulator
Click Open to enter the flight simulation view. Input location and environment parameters and click
Congure to save. Click Start Simulation to enter ight simulation practice.
Basic Settings
Congure the idle speed of and test the motor.
Connecting the Remote Controller
1. Connect the USB-C port of t he remote controller to a computer with a USB A to A cable, and then
power on the remote controller.
2. Swipe from the top of the screen, and make sure that the USB option is enabled.