dji AGRAS T30

©
2022 DJI All Rights Reserved.
25
AGRAS T30
Unmanned Aircraft Flight Manual
c. Obstacle Area: displays the value of the area of obstacles measured when planning elds for
Route operations.
d. Safety Margin Zone Area: displays the value of the area of the safety margin zone if the safety
margin is congured when planning elds for Route operations.
e. Sprayed Area: displays the value of the area already sprayed.
19. Operation List
: Displayed in M operation mode. Tap to view the planned elds and operations in progress and
invoke operations.
20. ParametersConguration
Tap to adjust operation parameters after entering any operation mode. The adjustable parameters
include spray amount, flight speed, route spacing, and the height of the aircraft above the
vegetation. The actual parameters that can be adjusted vary depending on the operation mode.
Command and Control Link
The command and control (C2) link between the aircraft and remote controller is established using DJI
OcuSync Enterprise transmission technology with the two OcuSync antennas on the aircraft and DJI
OcuSync Enterprise image transmission system, offering a maximum transmission range of 7 km. Its
performance is listed below.
Operating Frequency
SRRC/NCC/FCC/CE/MIC/KCC: 2.4000-2.4835 GHz
SRRC/NCC/FCC/CE: 5.725-5.850 GHz
Transmitter Power (EIRP)
2.4 GHz
SRRC/CE/MIC/KCC: ≤20 dBm, FCC/NCC: ≤30.5 dBm
5.8 GHz
SRRC: ≤21.5 dBm, FCC/NCC: ≤29.5 dBm, CE: ≤14 dBm
Ground Operational Area Setup
It is recommended to take off the aircraft in an open area. When taking off, the operator should be more
than 10 m away from the aircraft.
>10 m