dji AGRAS T30 - Page 77

©
2022 DJI All Rights Reserved.
75
AGRAS T30
Unmanned Aircraft Flight Manual
Installation
Make sure to remove the Intelligent Flight Battery from the aircraft before installation.
Operate with caution to avoid injury caused by sharp or moving mechanical parts.
1. Remove the bottom cover on the front of the aircraft. Pry the bottom cover from the gap between the
bottom cover and the rest of the aircraft using a tool if required. Be careful not to damage the cover.
c. Lift and remove the spray tank on the aircraft.
1
2
2
1
1
2
2. Remove the spray tank:
a. Unplug the liquid level gauge cable from the port at the bottom of the aircraft front, attach the
cover of the port, and remove the cable from the cable strainer at the bottom of the aircraft.
b. Use the double-ended wrench included in the aircraft package to remove the two nuts that
secure the aircraft and T-shaped connector on the spray tank, detach the T-shaped connector,
and attach the stopper to the hoses on the aircraft.