dji AGRAS T30 - Page 79

©
2022 DJI All Rights Reserved.
77
AGRAS T30
Unmanned Aircraft Flight Manual
6. Perform flow calibration before installing the fenders. Refer to the Spreading System Calibration
section for more information.
a. Place one of the fenders on one side of the spreader base, align the edge of the spreader base
to the slots on the fender, and insert the fender rmly.
b. Mount the fender for the other side in the same way. The screw holes at the point where the two
fenders meet must be aligned.
c. Insert two screws into the screw holes and tighten.
Check the parts on the aircraft and spreading system after installation to make sure that the
spinner disk will not damage the cables or any other part during operations.
Usage
Creating Templates
There are templates for several typical spreading materials in the spreading settings in the DJI Agras
app. In Route, A-B Route, or Manual Plus operation mode, users can select the template according to
the material used. If the performance of the existing templates is unsatisfactory or other materials are
being used, users can create a new template as follows:
1. Disassemble the spinner disk according to the instructions in the Maintenance section.
2. Make sure that the spreading system cable is connected and power on the remote controller and
aircraft. Tap
on the left of the screen in Operation View in the app to enter Spreading Settings.
3. Tap the dropdown menu for templates and then New Template.
4. Tap Flow Calibration and set the type of the hopper outlet in use. Tap Start Calibration and follow the
prompts to complete calibration.
When using the standard hopper gate that has been mounted to the spreading system before
delivery, set the hopper outlet type to Hopper Outlet 1. When using the small ow hopper
gate, set the hopper outlet type to Hopper Outlet 2. Refer to the Small Flow Hopper Gate
Product Information for installation.
5. Set the material amount, spinner disk speed, and ight speed. Tap Save.
6. Power off the aircraft and remount the spinner disk.
Spreading Operations
1. Power on the remote controller and then the aircraft. Enter Operation View in the DJI Agras app.
2. Open the cover, add compatible material, and close the cover. The DJI Agras app will intelligently
recommend the payload weight limit for the spread tank according to the current status and
surroundings of the aircraft. Do not exceed the recommended payload weight limit when adding
material to the tank. Otherwise, the ight safety may be affected.