DJI Mavic 3 User Manual
36
©
2021 DJI All Rights Reserved.
Remote Controller Alert
The remote controller vibrates or beeps when there is an error or warning. Pay attention when prompts
appear on the touchscreen or in DJI Fly. Slide down from the top to select Do Not Disturb or Mute to
disable some alerts.
Optimal Transmission Zone
The signal between the aircraft and the remote controller is most reliable when the antennas are
positioned in relation to the aircraft as illustrated below.
Do not use other wireless devices operating at the same frequency as the remote controller.
Otherwise, the remote controller will experience interference.
A prompt will be received in DJI Fly if the transmission signal is weak during flight. Adjust the
antennas to make sure that the aircraft is in the optimal transmission range.
Linking the Remote Controller
The aircraft and remote controller must be linked before use. Follow these steps to link a new remote
controller.
Method 1:
1. Power on the remote controller and the aircraft.
2. Press the C1, C2, and record button simultaneously until the status LED blinks blue and the remote
controller beeps.
3. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps once
to indicate it is ready to link. The aircraft beeps twice to indicate linking is successful. The battery
level LEDs of the remote controller will glow solid.
Method 2:
1. Power on the remote controller and the aircraft.
2. Launch DJI Fly.
3. In camera view, tap and select Control and Pair to Aircraft (Link).
4. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps once
indicating it is ready to link. The aircraft beeps twice indicating linking is successful. The battery level
LEDs of the remote controller will glow solid.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
