dji MAVIC 3T User Manual

DJI Mavic 3E/3T User Manual
86
©
2022 DJI All Rights Reserved.
Firmware Update
Use DJI Pilot 2 or DJI Assistant 2 (Enterprise Series) to update the remote controller, aircraft,
and other connected DJI devices.
Using DJI Pilot 2
1. Power on the aircraft and remote controller. Ensure the aircraft is linked to the remote
controller, their battery levels are higher than 25%, and the remote controller is
connected to the internet.
2. Run DJI Pilot 2. A prompt will appear on the homepage if new firmware is available. Tap
to enter the Firmware Update view.
3. Tap Update All, and DJI Pilot 2 will download the firmware and update the aircraft and
remote controller.
4. The aircraft and remote controller will automatically restart after the firmware update is
completed.
• Make sure the remote controller is charged over 25% before updating. The update
takes approximately 15 minutes (depending on network strength). Make sure the
remote controller is connected to the internet during the whole update process.
• The Intelligent Flight Battery installed on the aircraft will be updated to the latest
firmware version.
Offline Update
An offline firmware package can be downloaded from the DJI official website to an
external storage device such as a microSD card or U disk. Run DJI Pilot 2, tap HMS, and
then Firmware Update. Tap Offline Update to select the firmware package of the remote
controller or aircraft from the external storage device and tap Update All to update.
Using DJI Assistant 2 (Enterprise Series)
1. Connect the remote controller or aircraft to a computer separately, as the assistant
software does not support updating multiple DJI devices at the same time.
2. Make sure the computer is connected to the internet and the DJI device is powered on
with a battery level higher than 25%.
3. Launch DJI Assistant 2 and log in with a DJI account.
4. Tap the firmware update button on the left side.
5. Select the firmware version and tap to update. The firmware will be downloaded and
updated automatically.
6. When the "Update successful" prompt appears, the update is completed, and the DJI
device will restart automatically.

dji MAVIC 3T Specifications

General

Built-in processor	-
Internal memory	64 GB
Memory card slot(s)	Yes
Compatible memory cards	MicroSD (TransFlash)
AC adapter power	100 W
AC adapter frequency	50/60 Hz
AC adapter input voltage	100/240 V
AC adapter output current	2.5 A
Operating temperature (T-T)	-10 - 40 °C
Moving control functions	Backward, Downward, Forward, Upward
Megapixel	20 MP
Sensor type	CMOS
Video resolutions	1920 x 1080, 3840 x 2160, 4096 x 2160 pixels
Optical sensor size	1/2 \
Camera shutter speed	8-1/8000 s
Video formats supported	AVC, H.264, H.265, HEVC, MPEG4
Maximum image resolution	5280 x 3956 pixels
Field of view (FOV) angle	85 °
Supported video streaming modes	1080p
Battery voltage	7.2 V
Battery capacity	5000 mAh
Type	Quadcopter
Product color	Gray
USB ports quantity	1
Maximum speed	6 m/s
Frequency band	2.4 - 2.4835 GHz
Number of rotors	4 rotors
Maximum tilt angle	35 °
Hovering time (max)	45 min
Maximum ascent speed	1 m/s
Maximum weight capacity	- kg
Maximum wind resistance	12 m/s
Maximum operating distance	32000 m
Maximum yaw angular velocity	200 °/sec