DJI Mini 4 Pro
User Manual
114
©
2023 DJI All Rights Reserved.
List of Spare and Replacement Parts
1. DJI Mini 3 Pro Propellers
2. DJI Mini 4 Pro Intelligent Flight Battery
EASA Notice
Make sure to read the Drone Information Notices document included in the package before
use.
Visit the link below for more EASA notice information on traceability.
https://www.easa.europa.eu/en/document-library/general-publications/drones-information-
notices
Original Instructions
This manual is provided by SZ DJI Technology, Inc., and the content is subject to change.
Address: Lobby of T2, DJI Sky City, No. 53 Xianyuan Road, Xili Community, Xili Street, Nanshan
District, Shenzhen, China, 518055.
FAR Remote ID Compliance Information
The aircraft complies with the requirements of 14 CFR Part 89:
• The aircraft automatically broadcasts Remote ID messages from takeo to shut down. An
external device such as a cell phone or tablet is required to be connected as a location
source to DJI mobile devices without an integrated GNSS system
[1]
, and must run the DJI
ight control app such as DJI Fly in the foreground and always allow the DJI ight control app
to obtain its accurate location information. The connected external device must minimally be
one of the following:
1) FCC Certified personal wireless device that uses GPS with SBAS (WAAS) for location
services; or
2) FCC Certied personal wireless device with integrated GNSS.
Also, the external device must be operated in a way that does not interfere with the location
reported and its correlation to the operator location.
• The aircraft automatically initiates a pre-flight self-test (PFST) of the Remote ID system
before takeo and cannot take o if it does not pass the PFST
[2]
. The results of the PFST of
the Remote ID system can be viewed in either a DJI ight control app such as DJI Fly or DJI
goggles.
• The aircraft monitors the Remote ID system functionality from pre-ight to shut down. If the
Remote ID system malfunctions or has a failure, an alarm will be displayed in either a DJI
ight control app such as DJI Fly or DJI goggles.
Footnotes
[1] DJI mobile devices without an integrated GNSS system such as DJI RC-N2.
[2] The pass criterion for PFST is that the hardware and software of the Remote ID required-data source and
radio transmitter in the Remote ID system are functioning properly.
To Next Page
Loading...
Need help?
General
