To Next Page

To Previous Page

DJI Mini 4 Pro

User Manual

Takeo/Landing Procedures

1. Place the aircraft in an open, at area with the rear of the aircraft facing towards the user.

2. Power on the remote controller and the aircraft.

3. Launch DJI Fly and enter the camera view.

4. Tap Settings > Safety, and then set the Obstacle Avoidance Action to Bypass or Brake. Make

sure to set an appropriate Max Altitude and RTH Altitude.

5. Wait for the aircraft self-diagnostics to complete. If DJI Fly does not show any irregular

warning, you can start the motors.

6. Push the throttle stick up slowly to take o.

7. To land, hover over a level surface and push the throttle stick down to descend.

8. After landing, push the throttle down and hold until the motors stop.

9. Power o the aircraft before the remote controller.

Video Suggestions and Tips

1. The pre-ight checklist is designed to help the user y safely and shoot videos during ight.

Go through the full pre-ight checklist before each ight.

2. Select the desired gimbal operation mode in DJI Fly.

3. It is recommended to take photos or record videos when ying in Normal or Cine mode.

4. DO NOT y in bad weather such as on rainy or windy days.

5. Choose the camera settings that best suit your needs.

6. Perform ight tests to establish ight routes and preview scenes.

7. Push the control sticks gently to ensure smooth and stable movement of the aircraft.

• Make sure to place the aircraft on a flat and steady surface before takeoff. DO NOT

launch the aircraft from your palm or while holding it with your hand.

Questions and Answers:

Need help?

Do you have a question about the dji MINI 4 PRO and is the answer not in the manual?

dji MINI 4 PRO Specifications

General