dji MINI 4 PRO

DJI Mini 4 Pro
User Manual
©
2023 DJI All Rights Reserved.
73
downloaded at high speed. When connecting the mobile device to the aircraft for the rst
time, press and hold the power button of the aircraft for two seconds to conrm.
Method 2: mobile device is connected to the remote controller
1. Make sure that the aircraft is connected to the mobile device via the remote controller and
the motors are o.
2. Enable Bluetooth and Wi-Fi on the mobile device.
3. Launch DJI Fly, enter playback, and tap
in the upper right corner to access the les on the
aircraft to download at high speed.
• DJI RC 2 does not support QuickTransfer.
• The maximum download rate can only be achieved in countries and regions where the 5.8
GHz frequency is permitted by laws and regulations, when using devices that support 5.8
GHz frequency band and Wi-Fi connection, and in an environment without interference or
obstruction. If 5.8 GHz is not allowed by local regulations (such as in Japan), or the mobile
device of the user does not support the 5.8 GHz frequency band, or the environment
has severe interference, then QuickTransfer will use the 2.4 GHz frequency band and its
maximum download rate will reduce to 6 MB/s.
• Make sure that Bluetooth, Wi-Fi, and location services are enabled on the mobile device
before using QuickTransfer.
• When using QuickTransfer, it is not necessary to enter the Wi-Fi password on the
settings page of the mobile device in order to connect. Launch DJI Fly and a prompt will
appear to connect the aircraft.
• Use QuickTransfer in an unobstructed environment with no interference and stay
away from sources of interference such as wireless routers, Bluetooth speakers, or
headphones.