Ronin 2
User Manual
20
©
2017 DJI OSMO All Rights Reserved.
Using the Intelligent Battery
Check the Battery Level
Press the Battery Level button once to check the battery level.
Powering ON/OFF
Press and hold the Power button on the gimbal or Battery Mount to turn on the Ronin 2.
Make sure you unlock the pan, tilt, and roll axes before powering on the Ronin 2.
Heating the Battery
Manual Heating: When the battery is powered off, press and hold the Power button for 3
seconds to initiate battery warm-up manually.
The battery will warm up if the temperature is below 15° C (59° F). As it warms, Status
LED 1 & 2 and LED 3 & 4 will blink alternately. The battery will stop warming when it
reaches 20° C (68° F). The temperature of the battery will remain between 15-20° C (59-
68° F). When Status LED 1 and LED 4 blink alternately indicates a temperature above
15° C (59° F). This will last for approximately 30 minutes, then the Ronin 2 will power off
automatically.
Auto Heating: Insert the batteries into the aircraft and power on. When the temperature of
the battery is below 15° C (59° F), it will warm up automatically. Check the Status LEDs
for the current power level.
Low-Temperature Notice
1. The performance of the Intelligent Battery is signicantly reduced at low temperatures
(air temperatures below 5° C/41° F). Ensure that the battery is fully charged and the
cell voltage is at 4.35 V before use.
2. In extremely cold weather, the battery temperature may not be high enough even after
warming up. In these cases, insulate the battery as required.
3. To ensure optimum performance, keep the Intelligent Battery’s core temperature
above 20° C (68° F) when in use.
To Next Page
Loading...
Need help?
General
