36
©
2017 DJI OSMO All Rights Reserved.
Operation Modes
There are two operation modes for the Ronin 2: 3-Axis mode and Pan Lock mode.
3-Axis Mode
3-Axis mode is the standard, default mode. The Ronin 2 can be used in this mode without
any adjustments.
Pan Lock Mode
Pan Lock mode is specially designed for using the Ronin 2 with Steadicams. To use Pan
Lock mode:
1. Select the Handheld Mounting mode.
2. Enter the Settings page via the built-in touch panel and select “Pan Lock,” and then
the pan motor will shut off.
3. Lock the pan axis. The Ronin 2 will now work in Pan Lock mode.
4. To properly use Pan Lock mode, the pan axis locking accessory should be installed.
Please visit the ofcial DJI Online Store for more details.
Usage with a DJI A3 Flight Controller and Lightbridge
The Ronin 2 can be mounted to an aircraft with a DJI A3 Flight Controller and Lightbridge.
Connect the Ronin 2’s 14.4 V power/accessory port to the A3 Flight Controller, and
connect the Ronin 2’s CAN port to Lightbridge.
Maintenance
The Ronin 2 is a precise machine, and its power/data ports are not waterproof. Be sure
to protect them from dust and water during use. After use, it is recommended to wipe the
Ronin 2 down with a soft dry cloth. Never spray any cleaning liquids onto the Ronin 2.