dji RONIN 2 - Page 28

Ronin 2 User Manual
26
©
2017 DJI OSMO All Rights Reserved.
Monitor
Motor
Device
Log
Monitor
Pan Tilt Roll
1.4º
1.4º
4.5º
Angle
60%
212
1. Motor
Displays the power, angle, and temperature of motors. If
a particular motor axis indicates a power reading greater
than 10, this often means the mechanical balance of
the camera hasn’t been properly adjusted. A properly
balanced camera rig will display readings close to 0
power on each axis, but these values may vary.
2. Device
Displays the connection status with other devices, such
as the remote controller, GPS, Flight Controller, DJI
Focus, etc.
3. Log
Displays any abnormal status information of the gimbal.
1. Motion
The remote controller can have independently adjusted pan, tilt, and roll deadband
settings.
Deadband: When this value increases, more stick movement will be required to
translate into actual movement of the gimbal.
Max Speed: Allows you to adjust the remote-controlled rotational speed.
Smoothing: When this value increases, and when control stick input is released it
will be translated into smoother and slower movement. If smoothing is set to 0, the
slowdown will be translated as an abrupt stop.
Remote Control Settings
Motion
Channel
Remote
0
0
Left
Right
60%
212
0º
Deadband
10
Max Speed
50
Smoothing
15
Pan
Test Endpoint
60%
212
0º
Motion
Speed
Channel
Remote
CH 1
Nor
Roll
CH 2
Nor
Tilt
CH 3
Rev
Pan
CH 4
Rev
N/A
CH 5
Rev
N/A
CH 6
Rev
N/A