dji Ronin-MX - Step 2: Balancing the Roll Axis; Step 3: Balancing the Tilt Axis

Ronin-MX User Manual
14
©
2016 DJI All Rights Reserved.
4. With the gimbal facing outward on the tuning stand, slide the mounting plate into the
receiver until the safety lock engages. Adjust the vertical position of the crossbar to
meet the camera upper mounting plate.
5. When the camera achieves a rough balance, tighten the camera base side clamp and
the lock-knobs.
TIPS
You can adjust the tightness of the clamp with an M3 Allen wrench.
The steps above are suitable for most cameras. When mounting a RED or ARRI
camera, the proper camera accessories must be used.
6. You can also rotate the camera mounting plate 180 degrees to mount a camera upside-
down when necessary in certain congurations.
3. Mount the Camera Upper Mounting Plate to the top of the camera through the hot shoe
and then tighten the screws.
TIPS
When mounted on an aircraft, make sure the camera has a full, unobstructed range
of motion when pointed down at 90 degrees. If the power distribution box prevents a
full range of motion after it is balanced, try mounting the camera upside-down.