dji Ronin-MX - Calibrate System

Ronin-MX User Manual
©
2016 DJI All Rights Reserved.
25
CAUTION
Do not adjust the gimbal to the above position if Auto Sleep is disabled,
otherwise the gimbal may become damaged.
Calibrate System
Calibrate System is only used if you notice any kind of drift on any of the axes. To calibrate
the system, place the Ronin-MX on the tuning stand and make sure it is completely steady.
Be sure the camera can rotate 90 degrees with the lens pointing straight down, without
any interference from video monitor wires. Then tap the Calibrate System button and let the
process nish before picking up the Ronin-MX.
Do not touch or move the Ronin-MX during calibration.
Balance Test
Tap to check the balance status of the tilt and roll axis. Ensure there are no obstacles
present when running the Balance Test.
Activation
Activation is required when using your Ronin-MX for the rst time, otherwise the gimbal
will not work. To activate your Ronin-MX, connect your mobile device to the Internet, then
tap the “Activate” button.
Restore Default Settings
This will restore all of the factory default settings that can be congured through the DJI
Assistant app.
Device List
To force the DJI Assistant app to nd the Ronin-MX, open the “Device List” and the app
will search for Bluetooth devices it recognizes.
Auto Sleep
When Auto Sleep is enabled, adjust the Ronin-MX roll axis to 75 degrees or more (as
shown below), and the gimbal will turn off without turning off the Intelligent Battery or
other accessories. Recenter the tilt, pan and roll axes and position them horizontally to
bring the gimbal back out of Sleep mode.