DMP Electronics XTLplus SERIES - Device Setup; Device Name

XTLplus Installation and Programming Guide Digital Monitoring Products
21
DEVICE SETUP
25.3 Device Name
This section allows you to dene a 16 character alphanumeric name for the device
number. If no name is entered, *UNUSED* is displayed.
To remove a keypad from the system, delete the device name by pressing any
select area, then press the COMMAND key. The device name is now displayed as *
UNUSED *.
25.4 Wireless
Select YES to use a wireless keypad. Default is YES.
25.5 Serial Number
Enter the eight-digit serial number found on the wireless keypad.
25.6 Supervision Time
Press any top row key to select the supervision time required for the device. Press
COMMAND to accept the default time. Default is 240 minutes.
Press the select area under the required number of minutes. The device must
check in at least once during this time or a missing condition is indicated for that
device. Zero (0) indicates an unsupervised wireless keypad.
Note: When the panel is reset, panel is powered down and powered up, or
programming is complete, the supervision timer restarts for all wireless keypads.
Remote Options
26.1 Remote Options
This section allows you to enter the information needed for Remote Command/
Remote Programming operation via Wi-Fi communication. A description of the
Remote Options follows:
26.2 Remote Key
This option allows you to enter a code of up to eight digits for use in verifying
the authority of an alarm or service receiver to perform a remote command/
programming session. The receiver must give the correct key to the panel before
being allowed access. All panels are shipped from the factory with the Remote Key
preset as blank.
To enter a new Remote Key, press any select area and enter any combination of up
to 8 digits. The numbers you enter appear as asterisks.
Press COMMAND.
26.3 Remote Disarm
Enter YES to enable the panel to be disarmed remotely. Selecting NO disables
remote disarming. Default is YES.
26.4 App Key
Enter the 8-digit App Key obtained in your Dealer Settings tab at
dealeradmin.securecomwireless.com.
This option is a security feature of the Virtual Keypad iPhone/Android App used
only when your Dealer Settings at dealeradmin.securecomwireless.com have
“EASYconnect” set as the Communication Type.
This communication option is used to eliminate the need for a static IP address
programmed in Network Options.
To enter the App Key, press any select area and enter any combination
of 8 digits.
Press COMMAND. The default for this option is blank.
*UNUSED*
WIRELESS?NOYES
SERIAL#:XXXXXXXX
SUPRVSNTIME:240
SELECTMINUTES:
0 60 240
REMOTE OPTIONS
REMOTEOPTIONS
RMTKEY:
DISARM NO YES
APPKEY: