DNP DP-DS80D - Page 21

18
Dai Nippon Printing Co.,Ltd
[DP-DS80D Printer Driver] Instruction Manual for Windows 7,8
According to the contents of a printer error, the power supply of a printer needs to be re-switched on for error
recovery. In this case, it is not dependent on a setup of Print Re-try, and printing data in a printer buffer is cleared.
Operation by Print Re-try setup in each error is shown below.
Error Re-try Function for Duplex Printing
Contents of the error
Print Re-try setting is “Disable”
Print Re-try setting is “Enable”
Side the Error Occurs On
Front
Back
Front
Back
Paper End
Please resend picture
data not printed after
error recovery.
-
Printing processing is
resumed from the data
currently held in the
printer buffer after error
recovery.
When paper initializa-
tion operation is run, it
is printed after the paper
initialization operation.
-
Ribbon End
Regardless of Print
Re-try settings, once the
error is resolved,
printing processing is
resumed from data
currently held in the
printer buffer.
Regardless of Print
Re-try settings, once the
error is resolved,
printing processing is
resumed from data
currently held in the
printer buffer.
Cover Open
After the error is
resolved, resend the
print data including the
front image.
If the error occurs on
the back side, printing
of the back will
continue after the error
is resolved.
In cases where media
trouble prevents the
delivery of normal
prints, such as paper
jam, resend the image
data for both sides of
the print.
Paper Jam (*1)
Ribbon Error (*1)
Paper Definition Error
Scrap Box Error
Data Error
Error recovery requires
that the power supply of
the printer needs to be
turned OFF.
Therefore, print data in
the printer buffer is
cleared regardless of the
setup of the Print
Re-try function.
Please resend the
picture data not printed
after the printer is
rebooted.
Because resolution of
the error requires the
printer to be turned
OFF, the image data in
the buffer will be
cleared regardless of
Print Re-try settings.
Also, even though the
front side is finished, it
will be aborted, so
after the printer is
rebooted, resend the
image data for both
sides of the print.
Error recovery requires
that the power supply of
the printer needs to be
turned OFF.
Therefore, print data in
the printer buffer is
cleared even if the Print
Re-try function is set to
"Enable".
Please resend the
picture data not printed
after the printer is
rebooted.
Because resolution of
the error requires the
printer to be turned
OFF, even if Print
Re-try is enabled, the
turning OFF of the
printer will clear the
data from the buffer.
Also, even though the
front side is finished, it
will be aborted, so after
the printer is rebooted,
resend the image data
for both sides of the
print.
Head Voltage Error
Head Position Error
Power Supply Fan Stop
Cutter Error
Abnormal Head Temp.
Abnormal Media Temp.
Ribbon Tension Error
RFID Module Error
Abnormal motor Temp.
System Error
*1: After an error stop, a paper or a ribbon should perform removal work of an error factor according to a printer user's
manual.