DNP DS-RX1 HS - Page 15

12
[DS-RX1 Printer Driver] Instruction Manual (For Windows 11)
Pages per Sheet Layout
Set the layout direction of an image when the Pages per Sheet setting is set for multiple divisions.
Border
Synchronized with Border in the Option.
Overcoat Finish
Set the overcoat finish method for the surface of printed items from the following two types.
Overcoat Finish
Function
Glossy
Create an item with a glossy finish.
Matte
Create an item with a matte finish.
Print Re-try
Specify whether to print data in the printer buffer after a printer error has been cleared.
Print Re-try
Function
Disable
Clear the print data in the printer buffer when a printer error occurs.
You must send the cleared print data again after the error is cleared.
When you use an application with an error recovery function, select
this option.
Enable
Save print data in the printer buffer when an error occurs.
The printing process is restarted from the saved data after the error
is cleared.
Note that if the power is switched off, the data is not saved.
Depending on the content of the printer error, it may be necessary to restart the printer to clear
the error. In such cases, the print data in the printer buffer is cleared regardless of the Print Re-
try setting.
The following section shows the operation for each Print Re-try setting by error.
Error content
When Print Re-try is “Disable”
When Print Re-try is “Enable”
Paper end
You must send the unprinted
image data again after the error
is cleared.
The printing process is restarted
from the data saved in the
printer buffer after the error is
cleared.
When the paper initialization
operation is to be carried out,
printing occurs afterwards.
Ribbon end
Cover open
Paper jam (*1)
Ribbon error (*1)
Paper setting error
Data error
Because the printer must be
switched on and off to clear the
error, the print data in the printer
buffer is cleared regardless of
the Print Re-try setting.
After the printer has restarted,
you must send the unprinted
image data again.
Because the printer must be
switched on and off to clear the
error, the print data in the printer
buffer is cleared by switching the
printer off, even when the Print
Re-try setting is “Enable”.
After the printer has restarted,
you must send the unprinted
image data again.
Head voltage error
Head position error
Power supply fan
stopped
Cutter error
Head temperature error
Media temperature error
Ribbon Tension Error
RFID module error
System error
*1: After the printer stops due to an error, follow the User Guide of the printer to eliminate the
cause of the paper or ribbon error.
2inch cut (Depending on the version of printer firmware being used, “Disable” may be the only option.)
In the case of the specific paper size, it sets up whether it cuts into two or more sheets by the
length of 2 inches.
2inch cut
Function
Disable
It cuts in usual size.
Enable
By the length of 2 inches, in the case of (6x4) and PR(4x6) size, it cuts
to two sheets, and, in the case of (6x8) size, it cuts to four sheets.