Head Restraints — Rear Seats
The head restraints on the outboard seats are not
adjustable. They automatically fold forward when the
rear seat is folded to a load floor position, but do not
return to their normal position when the rear seat is
raised. After returning either seat to its upright position,
raise the head restraint until it locks in place. The out-
board head restraints are not removable.
The center head restraint has limited adjustment. Lift
upward on the head restraint to raise it or push down-
ward on the head restraint to lower it.
WARNING!
Sitting in a seat with the head restraint in its lowered
position could result in serious injury or death in a
collision. Always make sure the outboard head
restraints are in their upright positions when the seat
is to be occupied.
NOTE:
For proper routing of a Child Seat Tether, see
page 161.
Head Restraint Removal — Rear Seats
The center head restraint can be adjusted when occu-
pied, or removed for Child Seat Tethering. To remove
the head restraint, raise it as far as it can go by pulling
upward. Then, push the release button at the base of
the post while pulling the head restraint upward. To
reinstall the head restraint, put the head restraint posts
into the holes and push downward. Then, adjust the
head restraint to the appropriate height.
WARNING!
•
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the preceding reinstallation instructions prior to
operating the vehicle or occupying a seat.
•
Sitting in a seat with the head restraint in its low-
ered position could result in serious injury or death
in a collision. Always make sure the outboard head
restraints are in their upright positions when the
seat is to be occupied.
NOTE:
For proper routing of a Child Seat Tether, see
page 161.
WARNING!
•
A loose head restraint thrown forward in a collision
or hard stop could cause serious injury or death to
occupants of the vehicle. Always securely stow
removed head restraints in a location outside the
occupant compartment.
•
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the preceding reinstallation instructions prior to
operating the vehicle or occupying a seat.
Power Folding Third Row Head
Restraints
For improved visibility when in REVERSE, the third row
head restraints can be folded using the Uconnect system.
Press the Controls button located on the bottom of the
Uconnect display.
Press the Headrest Fold button to power fold
the third row head restraints.
NOTE:
•
The head restraints can only be folded downward
using the Headrest Fold button. The head restraints
must be raised manually when occupying the third
row.
•
Do not fold if there are passengers seated in the
third row seats.
Rear Head Restraint
Center Head Restraint Release Button
GETTING TO KNOW YOUR VEHICLE 33
2
To Next Page
Loading...
