ENGINE OIL LIFE RESET
Use this QR code to access your digital
experience.
Oil Change Required
Your vehicle is equipped with an engine
oil change indicator system. The “Oil
Change Required” message will display
in the instrument cluster display for five
seconds after a single chime has sounded, to indicate
the next scheduled oil change interval. The engine oil
change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate,
dependent upon your personal driving style.
Unless reset, this message will continue to display each
time the ignition is placed in the ON/RUN position. To
turn off the message temporarily, push and release the
OK or arrow buttons. To reset the oil change indicator
system (after performing the scheduled maintenance),
refer to the following procedure.
Vehicles Equipped With Keyless Enter ‘n Go™ —
Ignition
Use the steering wheel instrument cluster display con-
trols for the following procedure(s):
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and place the ignition in the
ON/RUN position (do not start the engine).
2. Push and release the down
arrow button to
scroll downward through the main menu to “Vehicle
Info.”
3. Push and release the right
arrow button to
access the ”Oil Life” screen.
4. Push and hold the OK
button to reset oil life. If condi-
tions are met, the gauge and numeric display will
update to show 100%. If conditions are not met a
pop-up message of “To reset oil life engine must be
off with ignition in run” will be displayed (for five sec-
onds), and the user will remain at the Oil Life screen.
5. Push and release the up or down arrow but-
ton to exit the submenu screen.
NOTE:
If the indicator message illuminates when you start the
vehicle, the oil change indicator system did not reset. If
necessary, repeat this procedure.
Secondary Method Of Resetting Engine Oil Life
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and place the ignition to the
ON/RUN position (do not start the engine).
2. Fully press the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pushing the brake pedal, push the ENGINE
START/STOP button once to return the ignition to the
OFF position.
NOTE:
If the indicator message illuminates when you start the
vehicle, the oil change indicator system did not reset. If
necessary, repeat this procedure.
DISPLAY AND MESSAGES
Includes the following, but not limited to:
Front Seat Belts Unbuckled Driver Seat Belt Unbuckled Passenger Seat Belt Unbuckled
Traction Control Off Washer Fluid Low Oil Pressure Low
Oil Change Due Fuel Low Service Anti-lock Brake System
Service Electronic Throttle Control Service Power Steering Cruise Off
Cruise Ready ACC Override Cruise Set To XXX mph or km/h
Service Shifter Tire Pressure Screen With Low Tire(s) Service Tire Pressure System
Park Brake Engaged Brake Fluid Low Engine Temperature Hot
Lights On Right Front Turn Signal Light Out Right Rear Turn Signal Light Out
Left Front Turn Signal Light Out Left Rear Turn Signal Light Out Ignition or Accessory On
Scan me
GETTING TO KNOW YOUR INSTRUMENT PANEL 71
3
To Next Page
Loading...
