Page 15
05-02 Mounting the starter
Insert cable drum with knotted starter
rope, let the spring click into the carrier
and tighten screw.
05-02 Mounting the starter
To check the pretension of the rewind
spring, pull the starter rope out completely.
Cable roller must be able to turn at least
another 1/2 turn further.
05-02 Inserting the rewind spring
b) as spare part. Insert the spring unit secured
with wire, insert spring eye in housing and
push spring into housing pocket. Grease with
grease no. 944.360.000.
05-02 Mounting the starter
Take starter rope through the eyelet, pull
starter handle over the rope and secure
with knot.
05-02 Mounting the starter
Tension rewind spring by turning several
times, allow starter rope to slide onto cable
drum.
05-02 Mounting the starter
If the cable drum cannot turn any further,
reduce the pretensioning by letting out a
section of starter rope.
05 Starting system
To Next Page
Loading...
