Page 14
05-02 Removing the starting system
Remove the motor hood and tubular
handle as described in introduction.
05-02 Removing the starting system
Loosen 4 screws and remove starter
cover.
05-02 Removing the cable drum
Pull out starter rope between cable drum
and starter housing. Relax rewind spring
by slowly letting the cable drum run back.
05-02 Insert rewind spring
a) Wind up rewind spring by hand.
Wind up spring in anti-clockwise direction.
Insert spring eye in housing. Grease
spring with grease no. 944.360.000.
05-02 Removing the starting system
Pull out the starter rope as far as it will go
and hold the drum tight.
05-02 Removing the cable drum
Loosen screw (1) and remove cable drum.
Take spring unit out of pocket with pincers.
1
05 Starting system
To Next Page
Loading...
