3.2.4. Door handle assembly (ALUMINUM DOOR OPTION)
The handle is inside the drum in a
plastic bag with 2 M-6x20 screws and 2
washers needed. Mounts to the door
with an Allen key nº 5.
3.3. Vapour extraction.
3.3.1. Entrance of fresh air
To ensure optimum performance and to minimize the length of the drying cycles, an input of fresh air
is required from outside the room. The fresh air inlet should be behind the dryer.
Fresh air ventilation opening shall not be blocked and or sealed.
The area of the fresh air inlet should be at least 4 times more than area of the air output pipe.
Note: The area of the fresh air inlet is equal to the area through the air is able to flow freely without
resistance from the bars or grille fitted across the entrance. Remember that the bars or vanes of the
grille often occupy a large portion of the area of the entrance.
To Next Page
Loading...
